Spacer kit for Ram 2500 and 3500
Popular Timbren SES kits were designed to work on pickup trucks with a standard ride height. But installing a lift kit on your pickup truck will increase the distance between the frame and the rear axle and, therefore, compromise the effectiveness of the Timbren SES helper springs. In other words, your lifted truck is still going to squat even after a Timbren SES rear kit has been installed. That’s where an approved Timbren spacer kit can fill the gap.
This spacer kit will enable you to haul your gear with confidence even if your lifted Ram 2500 has approximately 8.35” - 9.85” or your Ram 3500 has approximately 9” - 10.5” of space between the frame and the rear axle.
Here’s how it works: Each spacer kit comes with two 1 inch and two 1/2 inch spacers along with all the necessary hardware. This handy little kit helps you mix and match the spacers when you add them to the Timbren SES assembly allowing you to achieve your desired ride height.
Whether you’ve got a leveling kit, body lift or full suspension lift, Timbren spacer kits allow you to make effective use of your Timbren SES kit while hauling or towing your gear.
To determine whether you need a spacer kit, measure between the frame and rear axle of the truck when empty. If the gap between frame and axle for your Ram 2500 is approximately 8.35” - 9.85” or your Ram 3500 is approximatley 9” - 10.5” you will need to order a spacer kit.
Features & Benefits:
- Fully adjustable to achieve correct ride height
- Adapts Timbren SES kit to your lifted RAM 2500 & 3500 pickup truck
- Works with Timbren SES kit DR2500CA & DR3500CA
- Able to adjust Timbren SES ride height for up to 9.85 - 10.5”
What’s Included In The Box?
- 2x 1” rubber spacers
- 2x ½” rubber spacers
- All necessary hardware